Baths

Purpose: A water bath is laboratory equipment made from a mild steel/SS container filled with heated water. It is used to incubate samples in water at a constant temperature over a long period of time. Most water baths have a digital or an Analog to allow users to set a desired temperature. Utilizations include warming of reagents, melting of substrates or incubation of cell cultures. It is also used to enable certain chemical reactions to occur at high temperature. Water baths are preferred heat sources for heating flammable chemicals, as their lack of open flame prevents ignition. Different types of water baths are used depending on application. For all water baths, it can be used up to 99.9 °C when temperature is above 100 °C, alternative methods such as oil bath, silicone bath or sand bath may be used.

Standard Specification of Serological Water Bath:

1. Type of construction: Double walled rectangular chamber/single walled rectangular chamber.

2. Material of inner chamber & lid: Stainless steel 304.

3. Material of outer body:  Mild steel furnished with epoxy powder coating.

4. Insulation:  Glass wool/mineral wool/ solid insulation material /ceramic wool/rack wool insulation between inner & outer wall.

5. Temperature range:  5ᵒC above ambient to 99.9ᵒC.

6. Temperature accuracy in °C:  ±0.1°C to ± 5°C.

7. Temperature uniformity in °C.: ±0.1°C to ± 5°C.

8. Temperature Control Sensitivity: ±0.1°C to ±0.5°C.

9. Number of 75 mm diameter holes: 6/8/12/15/24.

10. Temperature controller: Microprocessor based PID/Digital temperature controller cum Indicator. Control panel has Heating & Temperature (Set & Actual) Indicators/ON/Off Switch/Power mains Indicator for precise control of temperature.

11. Water Bath Display Type: LED display.

12. Drain: Drain screw for fast and clean emptying of water bath.

13. Heating System: Heating is done by an immersion heater/ Internal Heating coil / U shaped tubular air heaters.

14. Temperature sensor: PT-100 temperature sensor is used for sensing the temperature.

15. Power Supply: 220 V 50 Hz Single Phase.

Technical Data& Ordering Information:-

Optional Features:

1. Timer.

2. Stainless Steel SS304.

3. Thermostat based control/ Analog Display.

4. Safety Features: High limit Alarm/Low fluid Alarm/Over temperature Alarm & cut off/safety thermostat/ Data Logging.

5. Water Bath Display Type: Digital (numerical/application specific) backlit LCD display/LCD/ Thermostatic control display.